Category: Delivery Pictures

CNC machine adjusting angular line

STEP1, loose two sides Y axis gantry bolts, both side loose, donot take them off

STEP 2, unplug signal line of Y1 or Y2, then when you move the Y axis gantry, there is only 1 side move, the otherside unplugged will stop moving, so you can adjust the angular line.

Delivery of 223AL09M

Delivery of aluminium expansion block with plastic backing sheets for U channel clamping glass

and end mill for CNC cutting and routing machine.

THIS product is used for aluminium U channel for clamping glass ,mainly for handrail purpose.

we also have many other shape of U channels for choice
with or without cover panel, if used onground, please chose cover panel. for underground use, mill finish is ok.
installed on the wall or edge of ground.

CNC JDPAINT.EXE operation manual

please download DSP control manual

DSP-MANULDownload

below is your 5mm sheet CAD drawing transfered to DXF filw which we removed all unnecessary items.

drawingDownload

open JDpaint, click IMPORT-2D DRAWING , click file type chose *.DXF

after imported, you will get below:

all drawing canbe imported at same time, but we need to export each single movement.

press shif to select groove line for all. and move outside of the drawing, delete the gray line.

select groove line
move to outside
delete the gray line

please use move command, distance X way -1500, when you move back, you can use same move command to move X way1500 back to place without any align.

open drawing toolbar, use line to connect uncloased groove line.

then click joint to make it whole. use default setting.

select all line until it change color, then you can move back to drawing.

Select groove line within the drawing, click Toolpaths-Toolpath wizard-Pocket Group-Rough Pocket

Change cut depth to 2mm

Cut depth change to 2mm
if you use 4mm end mill, please chose 4mm, right now we provide 6mm option.
Material you can chose aluminium or leave it without any choice
next page Feed setup-step setup, overlap ratio you can type 50%
Layer Setup-Layer mode chose Loyer count, count:2 layers.
Downstep change to 1mm, means each layer will cut 1mm depth only.
Slot setup, select close
Entry setup chose close, then press finish(完成)

CNC routing and cutting machine manul

1st, unzip software, winrar, 7z unzip, if you don’t have please download.

winrar_x64_501scDownload
7z_9.28.exe_Download

2nd, transfer software, transfer CAD DXF file to GCODE FOR REMOTE CONTROL USE. Here we use JD5.19, there are 4 7z file, please download in 1 folder，then use 7z unzip all. please add “.001-004″ behind the file name, otherwise it won’t work. please ignore the warning of changing file name will cause unable to use. the dot”.” must type, donot type blank space.

After you download this file, please add “.001” behind the file nameDownload
After you download this file, please add “.002” behind the file nameDownload
After you download this file, please add “.003” behind the file nameDownload
After you download this file, please add “.004” behind the file nameDownload

please click JDpaint.exe to Run programe

CAD dwg file should be transfered to DXF file

This file is the mesh of 5mm sheet you sent to me, we changed to DXFDownload

© Copyright 2025 Alco International Co., Ltd.

Theme : Bonkers